Well, here's a ship I've been working on for a little bit.
At the moment I'm calling it 'battleship thirty-twelve' for some reason. Its roughly the same size as the daedalus with the same role. Just made with new tech in mind.
nice details any close ups of those turrets? Ha was just thinking are you going to finish this model? I know my attention span is small also hopefully I will finish my current one!
This is a new one, got a full render in the works at the moment then I'll do a close up on the gun. Still some tweeks to make to it and some more textures to add, then this seciton will be pretty much done, also those little blank spots by the side.
Its supposed to be different to daedalus, basically battleship thirty-twelve is a story as well as a ship. Part of Tales of the Tau'ri Empire. (fan fiction I'm writing) There are eight main 500mm railguns and I'm probably going to add in two of the asgard beam weapons. A few smaller double barrel railgun turrets and some silos. The wings on the side of the neck are getting redone soon and then there's the super structure to add on the right side of the rear of the ship. Any suggestions and ideas that might help me along in my detail/model in general would be very nice.
They're 500mm railguns, and there aren't going to be any drone launchers, nuke launchers yes. You always need a few nukes on a spaceship.
There are eight 500mm railguns...
Yet again I've drifted from the matter at hand and have decided to work on the GWMC (yay...) Its a high tech naval vessel this time, and here's what I've for so far.
why not just have 20inch guns rather than mm. In naval terms the larger guns are measured in inches not mm.
Not a fan of the future ship it just looks like a runway and hanger on a boat there is no distinct design to it if you get me?
I'll never finish the boat in time due to a certain game retailer that didn't refund my purchase of Mass Effect 2, going to ring up the manager today. That should sort it out. I'll be continuing with the other ship from now on, I think I have kerky in the bag now.
Working on the inside of a ship Its 204m long and will probably have around 10 decks and a ton of rooms and corridors to greeble. Deck 1 is finished, starting work on deck -2. (There is no deck 0) Due to sci-fi meshes' ability to not let me upload as many pictures straight from my computer, most of this will appear on LS-A in the 'will's moddel masicare' thread in the 3D wips section. Or, you can wait a while for the next update, its easier just to visit the site...
Didn't like the old one, based too much on walkways rather than ship components. This one has an equally bad body, but a better inside layout. I'll get the exterior looks out of the way because i really don't like it at the moment. Then I'll start inside detail.
Posts
There are eight 500mm railguns...
Yet again I've drifted from the matter at hand and have decided to work on the GWMC (yay...) Its a high tech naval vessel this time, and here's what I've for so far.
12 inchers aren't called 1 footers.
Not a fan of the future ship it just looks like a runway and hanger on a boat there is no distinct design to it if you get me?
Podium + me = Water and... Whatever goes good with water.
Been gone so long because I've been sticking with LS-A for a while... And my sig makes me sound like a telemarketer.
Here's a big tanky render to get the thread up and running again:
Uploaded with ImageShack.us
(^Door to door salesman...^)