I probably will do the conference room eventually. I have the technique down from doing the Ent-B exterior wall for that, so it's likely but will depend on what references I can find. I specifically need a cross section (it's possible I already have one but will have to dig around).
It's roughly 29ft wide by 39ft long by my measure. I'm sure Rekkert's numbers will be a bit more accurate, though since he had access to stuff I'll never get to see. 🤣
Posts
Agreed that's pretty neat. You plugged a noise texture in the roughness slot I assume?
More tweaks. I think the command chairs are done now.
I am kidding. That's amazing.
Now that's funny as hell. Just might have to find a way to sneak that in...
In the same vein, then also an extremely polished section of the horseshoe display where Riker usually parks his ass?
Which version of the turbolift are you modeling? So the earlier version or the TNG-S7/Picard-S3 version?
How wide is the TNG bridge in feet?
It's roughly 29ft wide by 39ft long by my measure. I'm sure Rekkert's numbers will be a bit more accurate, though since he had access to stuff I'll never get to see. 🤣
More progress on the ready room: